Setting Parameters for the Data Synchronization Task


This section shows how to set the parameters in the data synchronization task.

Available Options for Parameters

You can specify constants, system variables, or custom variables for a parameter.

For more information on the system variables that are available, see Supported System Variables.

Procedure

  1. When you are in the data synchronization configuration panel, click Parameter Settings at the right edge of the panel.

  2. For each parameter that you use, provide the value using the key=value format. If you have multiple parameters to define, list each parameter in a new line, for example:

    key1=value1
    key2=value2
    


The value can be a single value, or an array of values.

Example: Using Parameters in the URL

In the example URL below, the test_list is a parameter.

s3://history/log_solar_dt_change_inverter/${test_list}.each_value


You can assign values for the parameter as per the following:

test_list=Array[20170515,20170516,20170517,20170518,20170519,20170520,20170521,20170522,20170523,20170524,20170808,20170905,20170906,20170918]

Figure: Example parameter settings